I use a miter saw (no blade tilt), prop the crown molding ... To cut your crown molding to fit the corner, you must know the angle formed by the two walls. The easiest way to do this is by using ...

Staff With the backer board secured to the wall’s top plate, you no longer have ... pieces of crown molding at an inside room corner. I prefer this type of joint over a miter joint because ...

Cut off the end of the mating molding piece squarely (no miter). Slide this piece up into the corner and nail it in place. Place the piece with the coped end over it and nail it in place ...

Cut off the end of the mating molding piece squarely (no miter). Slide this piece up into the corner and nail it in place. Place the piece with the coped end over it and nail it in place too.

To cut crown molding correctly you will need a compound miter saw. Each 90 degree angle, whether it is an inside corner or an outside corner, will be cut on a compound 45 degree angle. You can see ...

A miter saw is the best tool for making angled cuts in crown molding, baseboards and other types of trim. Many beginner DIYers and homeowners purchase a single-bevel 10-inch compound miter saw and ...

Start by cutting the molding as if you were going to miter the inside corner; be sure to leave the ... Or, mail to 4710 W. Dewey Drive, No. 100, Las Vegas, NV 89118. His web address is ...

Over time, this shrinks and becomes noticeable. It sounds as though it would be simple to miter cut the crown molding corners to 45 degrees, as on other trim, and fit the two ends together.

Fortunately, it’s much easier than it sounds. Start by cutting the molding as if you were going to miter the inside corner; be sure to leave the piece a few inches long. The mitered cut will ...